doc:hw_syntax
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
| doc:hw_syntax [2014/03/23 07:47] – admin | doc:hw_syntax [2014/03/23 07:57] – admin | ||
|---|---|---|---|
| Line 52: | Line 52: | ||
| ===== System Specific Commands (P 0) ===== | ===== System Specific Commands (P 0) ===== | ||
| - | ===== System Specific Commands (P 0) for the D2 Implementation | + | ==== System Specific Commands (P 0) for the D2 Implementation ==== |
| ^ Command | ^ Command | ||
| Line 81: | Line 81: | ||
| ===== Protocol Specific Commands (P 6) ===== | ===== Protocol Specific Commands (P 6) ===== | ||
| - | ====== Protocol Specific Commands (P 6) for the CAN UDS Protocol | + | ==== Protocol Specific Commands (P 6) for the CAN UDS Protocol ==== |
| ^ Command | ^ Command | ||
| Line 91: | Line 91: | ||
| | 9 | $xxx | 0 | set ECU Response-ID (SENDID) | | 9 | $xxx | 0 | set ECU Response-ID (SENDID) | ||
| - | ====== Protocol Specific Commands (P 6) for the CAN Raw Protocol | + | ==== Protocol Specific Commands (P 6) for the CAN Raw Protocol ==== |
| No dedicated p- commands for this mode, as the function is mainly driven by the sent data content. For more details about the CAN Raw Mode, please refer to the [[rfc_canraw-mode|RFC CAN Raw Mode]] | No dedicated p- commands for this mode, as the function is mainly driven by the sent data content. For more details about the CAN Raw Mode, please refer to the [[rfc_canraw-mode|RFC CAN Raw Mode]] | ||
| Line 97: | Line 97: | ||
| - | ====== Protocol Specific Commands (P 6) for the CAN RTD Protocol | + | ==== Protocol Specific Commands (P 6) for the CAN RTD Protocol ==== |
| For more details about the CAN RTD Mode, please refer to the [[rfc_rtd-real-time-data-protocol-for-the-oobd-firmware|RFC CAN RTD Mode]] | For more details about the CAN RTD Mode, please refer to the [[rfc_rtd-real-time-data-protocol-for-the-oobd-firmware|RFC CAN RTD Mode]] | ||
| Line 112: | Line 112: | ||
| ===== Bus Specific Commands (P 8) ===== | ===== Bus Specific Commands (P 8) ===== | ||
| - | ====== Bus Specific Commands (P 8) for the CAN Bus, used in D2 Design | + | ==== Bus Specific Commands (P 8) for the CAN Bus, used in D2 Design ==== |
| ^ Command | ^ Command | ||
| Line 136: | Line 136: | ||
| ===== Bus Generic Commands (P 9) ===== | ===== Bus Generic Commands (P 9) ===== | ||
| - | ===== Bus Generic Commands (P 9) for the CAN Bus ===== | + | ==== Bus Generic Commands (P 9) for the CAN Bus ==== |
| ^ Command | ^ Command | ||