Differences

This shows you the differences between two versions of the page.

--- doc:hw_commands [2016/11/27 17:05] – [Bus Generic Commands (P 9) for the CAN Bus] admin
+++ doc:hw_commands [2017/04/02 07:09] (current) – [Protocol Specific Commands (P 6) for the CAN UDS Protocol] admin
@@ Line 91: / Line 91: @@
 |  9  |  $xxx  |  0  | set ECU Response-ID (SENDID) (Default 0, makes SENDID= RECVID %%|%% 0x08)  |   |
 |  10  |  $xxx  |  0  | set Tester Present mask 02 xx (Default 0x80)  |   |
+|  11  |  0 or 1  |  0  | set/resets the [[rfc_canuds-mode#ping_mode_scan_available_modules|Ping Mode]] Flag  |   |
 ==== Protocol Specific Commands (P 6) for the CAN Raw Protocol ====
@@ Line 128: / Line 129: @@
 |  2  |  1  |  0  |CAN transceiver: Loop back (internal loop) |  |
 |  2  |  2  |  0  |CAN transceiver: Loop back combined with silent mode |  |
-|  2  |  3  |  0  |CAN transceiver: Normal mode (CAN active) |  |
+|  2  |  3  |  0  |CAN transceiver: Normal mode (CAN active) **ATTENTION**: You need to active the bus **before** you set the CAN-Filters, but not after, otherways the settings are lost and the filters are closed  |  |
 |  3  |  0 or 1  |  0  |Standard-CAN init (initialize CAN controller with 125kbit/s, 11bit) |  |
 |  3  |  2  |  0  |Standard-CAN init (initialize CAN controller with 250kbit/s, 11bit) |  |