doc:hw_commands
====== Differences ====== This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
doc:hw_commands [2017/03/18 12:50] admin [Protocol Specific Commands (P 6) for the CAN UDS Protocol] |
doc:hw_commands [2017/04/02 07:09] (current) admin [Protocol Specific Commands (P 6) for the CAN UDS Protocol] |
||
|---|---|---|---|
| Line 91: | Line 91: | ||
| | 9 | $xxx | 0 | set ECU Response-ID (SENDID) (Default 0, makes SENDID= RECVID %%|%% 0x08) | | | | 9 | $xxx | 0 | set ECU Response-ID (SENDID) (Default 0, makes SENDID= RECVID %%|%% 0x08) | | | ||
| | 10 | $xxx | 0 | set Tester Present mask 02 xx (Default 0x80) | | | | 10 | $xxx | 0 | set Tester Present mask 02 xx (Default 0x80) | | | ||
| - | | 11 | 0 or 1 | 0 | set/resets the Ping Mode Flag | | | + | | 11 | 0 or 1 | 0 | set/resets the [[rfc_canuds-mode#ping_mode_scan_available_modules|Ping Mode]] Flag | | |
| ==== Protocol Specific Commands (P 6) for the CAN Raw Protocol ==== | ==== Protocol Specific Commands (P 6) for the CAN Raw Protocol ==== | ||
doc/hw_commands.txt ยท Last modified: 2017/04/02 07:09 by admin
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
