doc:hw_commands
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
doc:hw_commands [2016/11/27 17:05] – [Bus Generic Commands (P 9) for the CAN Bus] admin | doc:hw_commands [2017/03/18 12:50] – [Protocol Specific Commands (P 6) for the CAN UDS Protocol] admin | ||
---|---|---|---|
Line 91: | Line 91: | ||
| 9 | $xxx | 0 | set ECU Response-ID (SENDID) (Default 0, makes SENDID= RECVID %%|%% 0x08) | | | | 9 | $xxx | 0 | set ECU Response-ID (SENDID) (Default 0, makes SENDID= RECVID %%|%% 0x08) | | | ||
| 10 | $xxx | 0 | set Tester Present mask 02 xx (Default 0x80) | | | | 10 | $xxx | 0 | set Tester Present mask 02 xx (Default 0x80) | | | ||
+ | | 11 | 0 or 1 | 0 | set/resets the Ping Mode Flag | | | ||
==== Protocol Specific Commands (P 6) for the CAN Raw Protocol ==== | ==== Protocol Specific Commands (P 6) for the CAN Raw Protocol ==== | ||
Line 128: | Line 129: | ||
| 2 | 1 | 0 |CAN transceiver: | | 2 | 1 | 0 |CAN transceiver: | ||
| 2 | 2 | 0 |CAN transceiver: | | 2 | 2 | 0 |CAN transceiver: | ||
- | | 2 | 3 | 0 |CAN transceiver: | + | | 2 | 3 | 0 |CAN transceiver: |
| 3 | 0 or 1 | 0 |Standard-CAN init (initialize CAN controller with 125kbit/s, 11bit) | | | | 3 | 0 or 1 | 0 |Standard-CAN init (initialize CAN controller with 125kbit/s, 11bit) | | | ||
| 3 | 2 | 0 |Standard-CAN init (initialize CAN controller with 250kbit/s, 11bit) | | | | 3 | 2 | 0 |Standard-CAN init (initialize CAN controller with 250kbit/s, 11bit) | | |
doc/hw_commands.txt · Last modified: 2017/04/02 07:09 by admin